498 | Interfaces
www.dell.com | support.dell.com
Monitor and Maintain Interfaces
Monitor interface statistics with the monitor interface command. This command displays an ongoing list of
the interface status (up/down), number of packets, traffic statistics, etc.
The information displays in a continuous run, refreshing every 2 seconds by default as shown in the
example below. Use the following keys to manage the output.
FTOS#monitor interface gi 3/1
FTOS uptime is 1 day(s), 4 hour(s), 31 minute(s)
Monitor time: 00:00:00 Refresh Intvl.: 2s
Interface: Gi 3/1, Disabled, Link is Down, Linespeed is 1000 Mbit
Traffic statistics: Current Rate Delta
Input bytes: 0 0 Bps 0
Output bytes: 0 0 Bps 0
Input packets: 0 0 pps 0
Output packets: 0 0 pps 0
64B packets: 0 0 pps 0
Over 64B packets: 0 0 pps 0
Over 127B packets: 0 0 pps 0
Command Syntax Command Mode Purpose
monitor interface interface EXEC Privilege View the interface’s statistics. Enter the type of interface and
slot/port information:
• For a 10/100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For the Management interface on the RPM, enter the
keyword
ManagementEthernet followed by the slot/port
information.
• For a SONET interface, enter the keyword sonet
followed by slot/port information.
• For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
m - Change mode c - Clear screen
l - Page up a - Page down
T - Increase refresh interval (by 1 second) t - Decrease refresh interval (by 1 second)
q - Quit
To Next Page
Loading...
