522 | IPv4 Routing
www.dell.com | support.dell.com
To view the configured static routes for the management port, use the show ip management-route command
in the EXEC privilege mode.
FTOS#show ip route static
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
S 2.1.2.0/24 Direct, Nu 0 0/0 00:02:30
S 6.1.2.0/24 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.2/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.3/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.4/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.5/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.6/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.7/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.8/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.9/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.10/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.11/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.12/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.13/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.14/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.15/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.16/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.17/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 11.1.1.0/24 Direct, Nu 0 0/0 00:02:30
Direct, Lo 0
--More--
Directed Broadcast
By default, FTOS drops directed broadcast packets destined for an interface. This default setting provides
some protection against Denial of Service (DOS) attacks.
To enable FTOS to receive directed broadcasts, use the following command in the INTERFACE mode:
To view the configuration, use the
show config command in the INTERFACE mode.
Command Syntax Command Mode Purpose
management route ip-address mask
{forwarding-router-address |
ManagementEthernet slot/port}
CONFIGURATION Assign a static route to point to the management
interface or forwarding router.
Command Syntax Command Mode Purpose
ip directed-broadcast
INTERFACE Enable directed broadcast.
To Next Page
Loading...
