Dell Force10 S4810P - Copy Configuration Files Using SNMP

Simple Network Management Protocol (SNMP) | 955
Copy Configuration Files Using SNMP
Use SNMP from a remote client to:
• copy the running-config file to the startup-config file, or
• copy configuration files from the Dell Force10 system to a server
• copy configuration files from a server to the Dell Force10 system
All of these tasks can be performed using IPv4 or IPv6 addresses. The examples in this section use IPv4
addresses; IPv6 addresses can be substituted for the IPv4 addresses in all of the examples.
The relevant MIBs for these functions are:
Trap SNMPv2-MIB::sysUpTime.0 = Timeticks: (1489568)
4:08:15.68,SNMPv2-MIB::snmpTrapOID.0 = OID: SNMPv2-SMI::mib-2.47.2.0.1,
SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 7
<cr> SNMP Copy Config Command Completed
%RPM0-P:CP %SNMP-4-RMON_RISING_THRESHOLD: RMON rising threshold alarm from SNMP
OID <oid>
%RPM0-P:CP %SNMP-4-RMON_FALLING_THRESHOLD: RMON falling threshold alarm from
SNMP OID <oid>
%RPM0-P:CP %SNMP-4-RMON_HC_RISING_THRESHOLD: RMON high-capacity rising threshold
alarm from SNMP OID <oid>
Table 46-3. MIB Objects for Copying Configuration Files via SNMP
MIB Object OID Object Values Description
copySrcFileType .1.3.6.1.4.1.6027.3.5.1.1.1.1.2 1 = FTOS file
2 = running-config
3 = startup-config
Specifies the type of file to copy from.
Range is:
• If the copySrcFileType is
running-config or startup-config,
the default copySrcFileLocation is
flash.
• If the copySrcFileType is a binary
file, the copySrcFileLocation and
copySrcFileName must also be
specified.
copySrcFileLocation .1.3.6.1.4.1.6027.3.5.1.1.1.1.3 1 = flash
2 = slot0
3 = tftp
4 = ftp
5 = scp
6 = usbflash
Specifies the location of source file.
• If the copySrcFileLocation is FTP
or SCP, copyServerAddress,
copyUserName, and
copyUserPassword must be
specified.
Table 46-2. Dell Force10 Enterprise-specific SNMP Traps
Command Option Trap