EasyManua.ls Logo

Dell Force10 S4810P - Installing an AC or DC Power Supply; Replacing an AC or DC Power Supply

Dell Force10 S4810P
1144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
40 | Configuration Fundamentals
www.dell.com | support.dell.com
find displays the output of the show command beginning from the first occurrence of specified text
Figure 2-11 shows this command used in combination with the command
show linecard all.
Figure 2-11. Filtering Command Outputs with the find Command
display displays additional configuration information.
no-more displays the output all at once rather than one screen at a time. This is similar to the command
terminal length except that the no-more option affects the output of the specified command only.
save copies the output to a file for future reference.
Multiple Users in Configuration mode
FTOS notifies all users in the event that there are multiple users logged into CONFIGURATION mode. A
warning message indicates the username, type of connection (console or vty), and in the case of a vty
connection, the IP address of the terminal on which the connection was established. For example:
On the system that telnets into the switch, Message 1 appears:
On the system that is connected over the console, Message 2 appears:
If either of these messages appears, Dell Force10 recommends that you coordinate with the users listed in
the message so that you do not unintentionally overwrite each others configuration changes.
Note: You can filter a single command output multiple times. The save option should be the last option
entered. For example:
FTOS# command | grep regular-expression | except regular-expression
| grep other-regular-expression | find regular-expression | save
Message 1 Multiple Users in Configuration mode Telnet Message
% Warning: The following users are currently configuring the system:
User "<username>" on line console0
Message 2 Multiple Users in Configuration mode Telnet Message
% Warning: User "<username>" on line vty0 "10.11.130.2" is in configuration mode
FTOS(conf)#do show linecard all | find 0
0 not present
1 not present
2 online online E48TB E48TB 1-1-463 48
3 not present
4 not present
5 online online E48VB E48VB 1-1-463 48
6 not present
7 not present

Table of Contents

Other manuals for Dell Force10 S4810P

Related product manuals