Dell Force10 S4810P - Manage Redundancy on an S-Series Stack; Reset a Unit on an S-Series Stack; Verifying a Stack Configuration; LED Status Indicators on an S4810 Stack

Stacking | 993
Manage Redundancy on an S-Series Stack
Reset a Unit on an S-Series Stack
You may reset any stack unit except for the master management unit (Message 2).
Verifying a Stack Configuration
LED Status Indicators on an S4810 Stack
The light of the LED status indicator on the front panel identifies the unit’s role in the stack.
• Off indicates the unit is a stack member.
• Blinking Green indicates the unit is the stack standby.
• Solid Green indicates the unit is the stack master (management unit)
Task Command Syntax Command Mode
Reset the current management unit, and make
the standby unit the new master unit. A new
standby is elected. When the former stack
master comes back online, it becomes a
member unit.
redundancy force-failover stack-unit
EXEC Privilege
Prevent the stack master from rebooting after a
failover. This command does not affect a
forced failover, manual reset, or a stack-link
disconnect.
redundancy disable-auto-reboot stack-unit
CONFIGURATION
Display redundancy information.
show redundancy
EXEC Privilege
Message 2 Master Reset Disallowed
% Error: Reset of master unit is not allowed.
Task Command Syntax Command Mode
Reload a stack-unit
reset stack-unit
EXEC Privilege
Reload a member unit, from the unit itself
reset-self
EXEC Privilege
Reset a stack-unit when the unit is in a problem state.
reset stack-unit {hard}
EXEC Privilege