Dell Force10 S4810P - View CAM-ACL Settings

282 | Content Addressable Memory (CAM)
www.dell.com | support.dell.com
FTOS#show cam-profile
-- Chassis CAM Profile --
CamSize : 18-Meg
: Current Settings : Next Boot
Profile Name : Default : Default
L2FIB : 32K entries : 32K entries
L2ACL : 1K entries : 1K entries
IPv4FIB : 256K entries : 256K entries
IPv4ACL : 12K entries : 12K entries
IPv4Flow : 24K entries : 24K entries
EgL2ACL : 1K entries : 1K entries
EgIPv4ACL : 1K entries : 1K entries
Reserved : 8K entries : 8K entries
FIB : 0 entries : 0 entries
ACL : 0 entries : 0 entries
Flow : 0 entries : 0 entries
EgACL : 0 entries : 0 entries
MicroCode Name : Default : Default
--More--
View a brief output of the command show cam-profile using the summary option.
The command
show running-config cam-profile shows the current profile and microcode as shown in the
following example.
FTOS#show running-config cam-profile
!
cam-profile default microcode default
FTOS#
View CAM-ACL settings
The show cam-acl command is supported on platforms c s
View the current cam-acl settings for the C-Series, S-Series and systems chassis and each
component using the command
show cam-acl, as shown in as shown in the following examples.
The default values for the
show cam-acl command for C-Series and S-Series are:
FTOS# show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Note: If you select the CAM profile from CONFIGURATION mode, the output of this command does not
reflect any changes until you save the running-configuration and reload the chassis.