Dell Force10 S4810P - Dynamic Counters

Interfaces | 515
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
Received 0 input symbol errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 IP Checksum, 0 overrun, 0 discarded
0 packets output, 0 bytes, 0 underruns
Output 0 Multicasts, 0 Broadcasts, 0 Unicasts
0 IP Packets, 0 Vlans, 0 MPLS
0 throttles, 0 discarded
Rate info (interval 100 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 1d23h42m
Dynamic Counters
By default, counting for the following four applications is enabled:
• IPFLOW
• IPACL
• L2ACL
• L2FIB
For remaining applications, FTOS automatically turns on counting when the application is enabled, and is
turned off when the application is disabled. Please note that if more than four counter-dependent
applications are enabled on a port pipe, there is an impact on line rate performance.
The following counter-dependent applications are supported by FTOS:
• Egress VLAN
• Ingress VLAN
• Next Hop 2
• Next Hop 1
• Egress ACLs
• ILM
• IP FLOW
• IP ACL
• IP FIB
• L2 ACL
• L2 FIB
Clear interface counters
The counters in the show interfaces command are reset by the clear counters command. This command
does not clear the counters captured by any SNMP program.