Dell Force10 S4810P Configuration Guide

616 | Link Aggregation Control Protocol (LACP)
www.dell.com | support.dell.com
Summary of the configuration on ALPHA
Summary of the configuration on ALPHA.
Alpha(conf-if-po-10)#int gig 2/31
Alpha(conf-if-gi-2/31)#no ip address
Alpha(conf-if-gi-2/31)#no switchport
Alpha(conf-if-gi-2/31)#shutdown
Alpha(conf-if-gi-2/31)#port-channel-protocol lacp
Alpha(conf-if-gi-2/31-lacp)#port-channel 10 mode active
Alpha(conf-if-gi-2/31-lacp)#no shut
Alpha(conf-if-gi-2/31)#show config
!
interface GigabitEthernet 2/31
no ip address
!
port-channel-protocol LACP
port-channel 10 mode active
no shutdown
!
Alpha(conf-if-gi-2/31)#
interface Port-channel 10
no ip address
switchport
no shutdown
interface GigabitEthernet 2/31
no ip address
no switchport
switchport
port-channel-protocol LACP
port-channel 10 mode active
no shutdown

Dell Force10 S4810P Specifications

General

Switching Capacity	1.28 Tbps
Forwarding Rate	952 Mpps
Manageable	Yes
Jumbo Frame Support	Yes
Jumbo Frame Size	9216 bytes
Input Voltage	100-240 VAC
Form Factor	Rack-mountable
Rack Height	1U
Power Supply	Dual, Hot-swappable
Product Type	Switch
Operating Temperature	32°F to 104°F (0°C to 40°C)
Operating Humidity	10% to 90% (non-condensing)
Latency	480 ns
MAC Address Table Size	128K entries