478 | Interfaces
www.dell.com | support.dell.com
You can only configure one (1) primary IP address per interface. You can configure up to 255 secondary IP
addresses on a single interface.
To view all interfaces to see with an IP address assigned, use the
show ip interfaces brief command in the
EXEC mode as shown in View Basic Interface Information.
To view IP information on an interface in Layer 3 mode, use the
show ip interface command in the EXEC
Privilege mode as shown in the example below.
FTOS>show ip int vlan 58
Vlan 58 is up, line protocol is up
Internet address is 1.1.49.1/24
Broadcast address is 1.1.49.255
Address determined by config file
MTU is 1554 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
Management Interfaces
The S4810 system supports the Management Ethernet interface as well as the standard S-Series interface
on any port. Either method can be used to connect to the system.
Configure Management Interfaces on the E-Series, C-Series
and the S4810
On the E-Series, C-Series, and S4810 the dedicated Management interface provides management access to
the system. You can configure this interface with FTOS, but the configuration options on this interface are
limited. Gateway addresses and IP addresses cannot be configured if it appears in the main routing table of
FTOS. In addition, Proxy ARP is not supported on this interface.
Note: On the S4810, a default IP address is assigned to the Management port. Use this IP address to set
your laptop Ethernet port to the same network for test purposes.
To Next Page
Loading...
