Dell Force10 S4810P - Create a Virtual Stack Unit on an S-Series Stack; Display Information about an S-Series Stack

990 | Stacking
www.dell.com | support.dell.com
Create a Virtual Stack Unit on an S-Series Stack
Use virtual stack units to configure ports on the stack before adding a new unit.
Display Information about an S-Series Stack
Display information about an S4810 stack using the show system command.
Force10#show system
Stack MAC : 00:01:e8:8a:df:e6
Reload Type : normal-reload
-- Unit 0 --
Unit Type : Management Unit
Status : online
Next Boot : online
Required Type : S4810 - 52-port GE/TE/FG (SE)
Current Type : S4810 - 52-port GE/TE/FG (SE)
Master priority : 0
Hardware Rev : 3.0
Num Ports : 64
Up Time : 57 min, 0 sec
FTOS Version : 8-3-7-13
Jumbo Capable : yes
POE Capable : no
Message 1 Renumbering the Stack Manager
Renumbering master unit will reload the stack.
WARNING: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]: yes
Task Command Syntax Command Mode
Create a virtual stack unit.
stack-unit provision
CONFIGURATION
Task Command Syntax Command Mode
Display for stack-identity, status, and
hardware information on every unit in a
stack. See the example below.
show system
EXEC Privilege
Display most of the information in show
system
, but in a more convenient tabular
form. See the example below.
show system brief
EXEC Privilege
Display the same information in show
system
, but only for the specified unit. See
the example below.
show system stack-unit
EXEC Privilege
Display topology and stack link status for
the entire stack. The available options
separate the show system stack-port
output into topology information from link
status information. See the example below.
show system stack-ports [status | topology] EXEC Privilege