Dell Force10 S4810P - Exclude Duplicate Entries; Exclude a Smaller Port Range; Overlap Port Ranges; Add Ranges

496 | Interfaces
www.dell.com | support.dell.com
Create a single-range
FTOS(config)# interface range gigabitethernet 5/1 - 23
FTOS(config-if-range-gi-5/1-23)# no shutdown
FTOS(config-if-range-gi-5/1-23)#
Create a multiple-range
FTOS(conf) #interface range tengigabitethernet 3/0 , gigabitethernet 2/1 - 47 , vlan 1000
FTOS(conf-if-range-gi-2/1-47,so-5/0)#
Exclude duplicate entries
Duplicate single interfaces and port ranges are excluded from the resulting interface range prompt:
FTOS(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3
FTOS(conf-if-range-vl-1,vl-3)#
FTOS(conf)
#interface range gigabitethernet 2/0 - 23 , gigabitethernet 2/0 - 23 , gigab 2/0 - 23
FTOS(conf-if-range-gi-2/0-23)#
Exclude a smaller port range
If interface range has multiple port ranges, the smaller port range is excluded from prompt:
FTOS(conf)#interface range gigabitethernet 2/0 - 23 , gigab 2/1 - 10
FTOS(conf-if-range-gi-2/0-23)#
Overlap port ranges
If overlapping port ranges are specified, the port range is extended to the smallest start port number and
largest end port number:
FTOS(conf)#inte ra gi 2/1 - 11 , gi 2/1 - 23
FTOS(conf-if-range-gi-2/1-23)#
Commas
The example below shows how to use commas to add different interface types to the range, enabling all
Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and 1/2.
FTOS(config-if)# interface range gigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2
FTOS(config-if-range-gi-5/1-23)# no shutdown
FTOS(config-if-range-gi-5/1-23)#
Add ranges
The example below shows how to use commas to add VLAN and port-channel interfaces to the range.