Dell Force10 S4810P - Page 956

956 | Simple Network Management Protocol (SNMP)
www.dell.com | support.dell.com
To copy a configuration file:
copySrcFileName .1.3.6.1.4.1.6027.3.5.1.1.1.1.4 Path (if file is not in
current directory)
and filename.
Specifies name of the file.
• If copySourceFileType is set to
running-config or startup-config,
copySrcFileName is not required.
copyDestFileType .1.3.6.1.4.1.6027.3.5.1.1.1.1.5 1 = FTOS file
2 = running-config
3 = startup-config
Specifies the type of file to copy to.
• If the copySourceFileType is
running-config or startup-config,
the default copyDestFileLocation is
flash.
• If the copyDestFileType is a binary
the copyDestFileLocation and
copyDestFileName must be
specified.
copyDestFileLocation .1.3.6.1.4.1.6027.3.5.1.1.1.1.6 1 = flash
2 = slot0
3 = tftp
4 = ftp
5 = scp
Specifies the location of destination
file.
• If the copyDestFileLocation is FTP
or SCP, copyServerAddress,
copyUserName, and
copyUserPassword must be
specified.
copyDestFileName .1.3.6.1.4.1.6027.3.5.1.1.1.1.7 Path (if file is not in
default directory)
and filename.
Specifies the name of destination file.
copyServerAddress .1.3.6.1.4.1.6027.3.5.1.1.1.1.8 IP Address of the
server
The IP address of the server.
• If the copyServerAddress is
specified so must copyUserName,
and copyUserPassword.
copyUserName .1.3.6.1.4.1.6027.3.5.1.1.1.1.9 Username for the
server.
Username for the FTP, TFTP, or SCP
server.
• If the copyUserName is specified so
must copyUserPassword.
copyUserPassword .1.3.6.1.4.1.6027.3.5.1.1.1.1.10 Password for the
server.
Password for the FTP, TFTP, or SCP
server.
Step Task Command Syntax Command Mode
1 Create an SNMP community string with read/
write privileges.
snmp-server community
community-name rw
CONFIGURATION
2 Copy the f10-copy-config.mib MIB from the Dell Force10 iSupport webpage to the server to which you are
copying the configuration file.
Table 46-3. MIB Objects for Copying Configuration Files via SNMP
MIB Object OID Object Values Description