Management | 55
The configuration in the following example creates privilege level 3. This level:
• removes the
resequence command from EXEC mode by requiring a minimum of privilege level 4
• moves the command
capture bgp-pdu max-buffer-size from EXEC Privilege to EXEC mode by requiring
a minimum privilege level 3, which is the configured level for VTY 0
• allows access to CONFIGURATION mode with the
banner command
• allows access to INTERFACE and LINE modes are allowed with no commands
FTOS(conf)#do show run priv
!
privilege exec level 3 capture
privilege exec level 3 configure
privilege exec level 4 resequence
privilege exec level 3 capture bgp-pdu
privilege exec level 3 capture bgp-pdu max-buffer-size
privilege configure level 3 line
privilege configure level 3 interface
FTOS(conf)#do telnet 10.11.80.201
[telnet output omitted]
FTOS#show priv
Current privilege level is 3.
FTOS#?
capture Capture packet
configure Configuring from terminal
disable Turn off privileged commands
enable Turn on privileged commands
exit Exit from the EXEC
ip Global IP subcommands
monitor Monitoring feature
mtrace Trace reverse multicast path from destination to source
ping Send echo messages
quit Exit from the EXEC
show Show running system information
[output omitted]
FTOS#config
[output omitted]
FTOS(conf)#do show priv
Current privilege level is 3.
FTOS(conf)#?
Allow access to INTERFACE, LINE, ROUTE-MAP,
and/or ROUTER mode. Specify all keywords in the
command.
privilege configure level level
{interface | line | route-map |
router} {command-keyword ||...||
command-keyword}
CONFIGURATION
Allow access to a CONFIGURATION, INTERFACE,
LINE, ROUTE-MAP, and/or ROUTER mode command.
privilege {configure |interface | line
| route-map | router} level level
{command ||...|| command}
CONFIGURATION
Task Command Syntax Command Mode
To Next Page
Loading...
