Dell Force10 S4810P - Page 134

134 | Access Control Lists (ACLs)
www.dell.com | support.dell.com
match interface interface CONFIG-ROUTE-MAP Match routes whose next hop is a specific
interface. The parameters are:
• For a Fast Ethernet interface, enter the
keyword FastEthernet followed by the slot/
port information.
• For a 1-Gigabit Ethernet interface, enter the
keyword gigabitEthernet followed by the
slot/port information.
• For a loopback interface, enter the keyword
loopback followed by a number between
zero (0) and 16383.
• For a port channel interface, enter the keyword
port-channel followed by a number from 1
to 255 for TeraScale and ExaScale, 1 to 32 for
EtherScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the
keyword tengigabitEthernet followed by
the slot/port information.
• For a VLAN, enter the keyword vlan followed
by a number from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the
keyword
fortyGigE followed by the slot/port
information.
match ip address prefix-list-name CONFIG-ROUTE-MAP Match destination routes specified in a prefix list
(IPv4).
match ipv6 address prefix-list-name CONFIG-ROUTE-MAP Match destination routes specified in a prefix list
(IPv6).
match ip next-hop
{access-list-name | prefix-list
prefix-list-name}
CONFIG-ROUTE-MAP Match next-hop routes specified in a prefix list
(IPv4).
match ipv6 next-hop
{access-list-name | prefix-list
prefix-list-name}
CONFIG-ROUTE-MAP Match next-hop routes specified in a prefix list
(IPv6).
match ip route-source
{access-list-name | prefix-list
prefix-list-name}
CONFIG-ROUTE-MAP Match source routes specified in a prefix list
(IPv4).
match ipv6 route-source
{access-list-name | prefix-list
prefix-list-name}
CONFIG-ROUTE-MAP Match source routes specified in a prefix list
(IPv6).
match metric metric-value CONFIG-ROUTE-MAP Match routes with a specific value.
match origin {egp | igp |
incomplete}
CONFIG-ROUTE-MAP Match BGP routes based on the ORIGIN attribute.
match route-type {external
[type-1 | type-2] | internal | level-1
| level-2
| local }
CONFIG-ROUTE-MAP Match routes specified as internal or external to
OSPF, ISIS level-1, ISIS level-2, or locally
generated.
Command Syntax Command Mode Purpose