Dell Force10 S4810P - Page 228

228 | Border Gateway Protocol
www.dell.com | support.dell.com
To view the BGP configuration, use the show config command in the ROUTER BGP mode. To view a
prefix list configuration, use the
show ip prefix-list detail or show ip prefix-list summary commands in
EXEC Privilege mode.
Use these commands in the following sequence, starting in the CONFIGURATION mode to filter routes
using a route map.
Use the
show config command in CONFIGURATION ROUTER BGP mode to view the BGP
configuration. Use the
show route-map command in EXEC Privilege mode to view a route map
configuration.
Use these commands in the following sequence, beginning in the CONFIGURATION mode to filter routes
based on AS-PATH information.
Step Command Syntax Command Mode Purpose
1
route-map map-name [permit |
deny] [sequence-number]
CONFIGURATION Create a route map and assign it a name.
2
{match | set} CONFIG-ROUTE-MAP Create multiple route map filters with a
match or set action.
Refer to Chapter 6, “Access Control Lists
(ACLs),” on page 89 for information on
configuring route maps.
3
exit
CONFIG-ROUTE-MAP Return to the CONFIGURATION mode.
4
router bgp as-number CONFIGURATION Enter ROUTER BGP mode.
neighbor {ip-address |
peer-group-name} route-map
map-name {in | out}
CONFIG-ROUTER-BGP Filter routes based on the criteria in the
configured route map. Configure the
following parameters:
• ip-address or peer-group-name: enter
the neighbor’s IP address or the peer
group’s name.
• map-name: enter the name of a
configured route map.
• in: apply the route map to inbound
routes.
• out: apply the route map to outbound
routes.
Step Command Syntax Command Mode Purpose
1
ip as-path access-list
as-path-name
CONFIGURATION Create a AS-PATH ACL and assign it a name.
2
{deny | permit}
as-regular-expression
AS-PATH ACL Create a AS-PATH ACL filter with a deny or
permit action.
3
exit
AS-PATH ACL Return to the CONFIGURATION mode.
4
router bgp as-number CONFIGURATION Enter ROUTER BGP mode.