Dell Force10 S4810P - Page 230

230 | Border Gateway Protocol
www.dell.com | support.dell.com
When you enable a route reflector, FTOS automatically enables route reflection to all clients. To disable
route reflection between all clients in this reflector, use the
no bgp client-to-client reflection command in
CONFIGURATION ROUTER BGP mode. All clients should be fully meshed before you disable route
reflection.
Aggregate routes
FTOS provides multiple ways to aggregate routes in the BGP routing table. At least one specific route of
the aggregate must be in the routing table for the configured aggregate to become active.
Use the following command in the CONFIGURATION ROUTER BGP mode to aggregate routes.
AS_SET includes AS_PATH and community information from the routes included in the aggregated route.
In the
show ip bgp command, aggregates contain an ‘a’ in the first column and routes suppressed by the
aggregate contain an ‘s’ in the first column.
Figure 9-30. Command Example: show ip bgp
Command Syntax Command Mode Purpose
aggregate-address ip-address
mask [advertise-map map-name]
[as-set] [attribute-map map-name]
[summary-only] [suppress-map
map-name]
CONFIG-ROUTER-BGP Assign the IP address and mask of the prefix to be
aggregated.
Optional parameters are:
• advertise-map map-name: set filters for
advertising an aggregate route
• as-set: generate path attribute information and
include it in the aggregate.
• attribute-map map-name: modify attributes of
the aggregate, except for the AS_PATH and
NEXT_HOP attributes
• summary-only: advertise only the aggregate
address. Specific routes will not be advertised
• suppress-map map-name: identify which
more-specific routes in the aggregate are suppressed
FTOS#show ip bgp
BGP table version is 0, local router ID is 10.101.15.13
Status codes: s suppressed, d damped, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*> 7.0.0.0/29 10.114.8.33 0 0 18508 ?
*> 7.0.0.0/30 10.114.8.33 0 0 18508 ?
*>a 9.0.0.0/8 192.0.0.0 32768 18508 701 {7018 2686 3786} ?
*> 9.2.0.0/16 10.114.8.33 0 18508 701 i
*> 9.141.128.0/24 10.114.8.33 0 18508 701 7018 2686 ?
FTOS#
Aggregate Route
Indicators