Data Center Bridging (DCB) | 309
3 Configure the CoS traffic to be stopped for the specified
delay. Enter the 802.1p values of the frames to be
paused.
Range: 0-7.
Default: None.
Maximum number of loss less queues supported on the
switch: 2.
Separate priority values with a comma. Specify a
priority range with a dash, for example: pfc priority
1,3,5-7.
pfc priority priority-range
DCB INPUT POLICY
4 Enable the PFC configuration on the port so that the
priorities are included in DCBx negotiation with peer
PFC devices. Default: PFC mode is on.
pfc mode on
DCB INPUT POLICY
5 (Optional) Enter a text description of the input policy.
Maximum: 32 characters.
description text
DCB INPUT POLICY
6 Exit DCB input policy configuration mode.
exit
DCB INPUT POLICY
7 Enter interface configuration mode.
interface type slot/port
CONFIGURATION
8 Apply the input policy with the PFC configuration to an
ingress interface.
dcb-policy input
policy-name
INTERFACE
9 Repeat Steps 1 to 8 on all PFC-enabled peer interfaces to ensure lossless traffic service.
Step Task Command Command Mode
To Next Page
Loading...
