Data Center Bridging (DCB) | 331
4 Configure the PFC and ETS TLVs to be advertised on
un-configured interfaces with a manual port-role, where:
•
ets-conf enables transmission of ETS Configuration
TLVs.
•
ets-reco enables transmission of ETS Recommend
TLVs.
•
pfc enables transmission of PFC TLVs.
Note: You can configure the transmission of more than
one TLV type at a time. ETS recommend TLVs (ets-reco)
can be enabled only if ETS configuration TLVs (ets-conf)
are enabled. To disable TLV transmission, use the no form
of the command; for example, no advertise DCBx-tlv pfc
ets-reco.
Default: All TLV types are enabled.
[no] advertise DCBx-tlv
{ets-conf | ets-reco | pfc}
[ets-conf | ets-reco | pfc]
[ets-conf | ets-reco | pfc]
PROTOCOL LLDP
5 Configure the Application Priority TLVs to be advertised
on un-configured interfaces with a manual port-role,
where:
• fcoe enables the advertisement of FCoE in Application
Priority TLVs.
• iscsi enables the advertisement of iSCSI in
Application Priority TLVs.
Default: Application Priority TLVs are enabled and
advertise FCoE and iSCSI.
Note: To disable TLV transmission, use the no form of the
command; for example, no advertise DCBx-appln-tlv iscsi.
For information about how to use FCoE and iSCSI, refer
to FIP Snooping and iSCSI Optimization.
[no] advertise DCBx-appln-tlv
{fcoe | iscsi}
PROTOCOL LLDP
6 Configure the FCoE priority advertised for the FCoE
protocol in Application Priority TLVs.
The priority-bitmap range is from 1 to FF.
Default: 0x8.
[no] fcoe priority-bits
priority-bitmap
PROTOCOL LLDP
7 Configure the iSCSI priority advertised for the iSCSI
protocol in Application Priority TLVs.
The priority-bitmap range is from 1 to FF.
Default: 0x10.
[no] iscsi priority-bits
priority-bitmap
PROTOCOL LLDP
Step Task Command Command Mode
To Next Page
Loading...
