344 | Data Center Bridging (DCB)
www.dell.com | support.dell.com
Figure 13-17. show interface DCBx detail for legacy cee Command Example
Table 13-5. show interface DCBx detail Command Description
Field Description
Interface Interface type with chassis slot and port number.
Port-Role Configured DCBx port role: auto-upstream, auto-downstream, config-source,
or manual.
DCBx Operational Status Operational status (enabled or disabled) used to elect a configuration source
and internally propagate a DCB configuration. The DCBx operational status is
the combination of PFC and ETS operational status.
Configuration Source Specifies whether the port serves as the DCBx configuration source on the
switch: true (yes) or false (no).
FTOS(conf-if-te-0/17-lldp)#do sho int te 1/14 dc d
E-ETS Configuration TLV enabled e-ETS Configuration TLV disabled
R-ETS Recommendation TLV enabled r-ETS Recommendation TLV disabled
P-PFC Configuration TLV enabled p-PFC Configuration TLV disabled
F-Application priority for FCOE enabled f-Application Priority for FCOE disabled
I-Application priority for iSCSI enabled i-Application Priority for iSCSI disabled
------------------------------------------------------------------------------------------
Interface TenGigabitEthernet 1/14
Remote Mac Address 00:01:e8:8a:df:a0
Port Role is Auto-Upstream
DCBx Operational Status is Enabled
Is Configuration Source? FALSE
Local DCBx Compatibility mode is CEE
Local DCBx Configured mode is CEE
Peer Operating version is CEE
Local DCBx TLVs Transmitted: ErPFi
Local DCBx Status
-----------------
DCBx Operational Version is 0
DCBx Max Version Supported is 0
Sequence Number: 1
Acknowledgment Number: 1
Protocol State: In-Sync
Peer DCBx Status:
----------------
DCBx Operational Version is 0
DCBx Max Version Supported is 0
Sequence Number: 1
Acknowledgment Number: 1
Total DCBx Frames transmitted 994
Total DCBx Frames received 646
Total DCBx Frame errors 0
Total DCBx Frames unrecognized 0
To Next Page
Loading...
