Dell Force10 S4810P - Page 366

366 | S-Series Debugging and Diagnostics
www.dell.com | support.dell.com
Figure 14-9. Display the Default Buffer Profile
Figure 14-10. Displaying Buffer Profile Allocations
FTOS#show buffer-profile detail interface gigabitethernet 0/1
Interface Gi 0/1
Buffer-profile -
Dynamic buffer 194.88 (Kilobytes)
Queue# Dedicated Buffer Buffer Packets
(Kilobytes)
0 2.50 256
1 2.50 256
2 2.50 256
3 2.50 256
4 9.38 256
5 9.38 256
6 9.38 256
7 9.38 256
FTOS#show running-config interface tengigabitethernet 2/0 !
interface TenGigabitEthernet 2/0
no ip address
mtu 9252
switchport
no shutdown
buffer-policy myfsbufferprofile
FTOS#sho buffer-profile detail int gi 0/10
Interface Gi 0/10
Buffer-profile fsqueue-fp
Dynamic buffer 1256.00 (Kilobytes)
Queue# Dedicated Buffer Buffer Packets
(Kilobytes)
0 3.00 256
1 3.00 256
2 3.00 256
3 3.00 256
4 3.00 256
5 3.00 256
6 3.00 256
7 3.00 256
FTOS#sho buffer-profile detail fp-uplink stack-unit 0 port-set 0
Linecard 0 Port-set 0
Buffer-profile fsqueue-hig
Dynamic Buffer 1256.00 (Kilobytes)
Queue# Dedicated Buffer Buffer Packets
(Kilobytes)
0 3.00 256
1 3.00 256
2 3.00 256
3 3.00 256
4 3.00 256
5 3.00 256
6 3.00 256
7 3.00 256