Dell Force10 S4810P - Page 473

Interfaces | 473
Input Statistics:
0 packets, 0 bytes
0 Vlans
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
3 packets, 192 bytes, 0 underruns
3 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 3 Broadcasts, 0 Unicasts
0 Vlans, 0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:00:31
FTOS#
Use the show ip interfaces brief command in the EXEC Privilege mode to view which interfaces are
enabled for Layer 3 data transmission. In the following example, GigabitEthernet interface 1/5 is in Layer
3 mode since an IP address has been assigned to it and the interface’s status is operationally up.
FTOS#show ip interface brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet 1/0 unassigned NO Manual administratively down down
GigabitEthernet 1/1 unassigned NO Manual administratively down down
GigabitEthernet 1/2 unassigned YES Manual up up
GigabitEthernet 1/3 unassigned YES Manual up up
GigabitEthernet 1/4 unassigned YES Manual up up
GigabitEthernet 1/5 10.10.10.1 YES Manual up up
GigabitEthernet 1/6 unassigned NO Manual administratively down down
GigabitEthernet 1/7 unassigned NO Manual administratively down down
GigabitEthernet 1/8 unassigned NO Manual administratively down down
Use the show interfaces configured command in the EXEC Privilege mode to view only configured
interfaces. In the previous example, GigabitEthernet interface 1/5 is in Layer 3 mode since an IP address
has been assigned to it and the interface’s status is operationally up.
To determine which physical interfaces are available, use the
show running-config command in EXEC
mode. This command displays all physical interfaces available on the line cards..
FTOS#show running
Current Configuration ...
!
interface GigabitEthernet 9/6