Dell Force10 S4810P

592 | Intermediate System to Intermediate System
www.dell.com | support.dell.com
IPv6 routes
Use any of the these commands in ROUTER ISIS ADDRESS-FAMILY IPV6 mode to add routes from
other routing instances or protocols.
Use the
show running-config isis command in EXEC Privilege mode to view IS-IS configuration globally
(including both IPv4 and IPv6 settings), or the
show config command in ROUTER ISIS mode to view the
current IPv4 IS-IS configuration, or the
show config command in ROUTER ISIS-ADDRESS FAMILY
IPV6 mode to view the current IPv6 IS-IS configuration
Configure authentication passwords
You can assign an authentication password for routers in Level 1 and for routers in Level 2. Since Level 1
and Level 2 routers do not communicate with each other, you can assign different passwords for Level 1
routers and for Level 2 routers. If you want the routers in the level to communicate with each other, though,
they must be configured with the same password.
Note: These commands apply to IPv6 IS-IS only. Use the ROUTER ISIS mode previously shown to apply
prefix lists to IPv4 routes.
Command Syntax Command Mode Purpose
redistribute {bgp as-number | connected | rip |
static
} [level-1 level-1-2 | level-2] [metric
metric-value] [metric-type {external | internal}]
[route-map map-name]
ROUTER ISIS Include BGP, directly connected, RIP, or
user-configured (static) routes in IS-IS.
Configure the following parameters:
•
level-1, level-1-2, or level-2: Assign
all redistributed routes to a level.
Default is
level-2.
• metric range: 0 to 16777215. Default is
0.
• metric-type: choose either external or
internal. Default is internal.
• map-name: name of a configured route
map.
redistribute ospf process-id [level-1| level-1-2 |
level-2] [metric
value] [match external {1 | 2} | match
internal
] [metric-type {external | internal}]
[route-map map-name]
ROUTER ISIS Include specific OSPF routes in IS-IS.
Configure the following parameters:
• process-id range: 1 to 65535
• level-1, level-1-2, or level-2: Assign
all redistributed routes to a level.
Default is level-2.
• metric range: 0 to 16777215. Default is
0.
• match external range: 1 or 2
• match internal
• metric-type: external or internal.
• map-name: name of a configured route
map.