Dell Force10 S4810P - Page 753

Open Shortest Path First (OSPFv2 and OSPFv3) | 753
Use the show running-config ospf command to see the state of all the enabled OSPFv2 processes.
Figure 34-20. Command Example: show running-config ospf
Use the following commands in EXEC Privilege mode to get general route and links status information.
Use the following command in EXEC Privilege mode to view the OSPFv2 configuration for a neighboring
router:
Command Syntax Command Mode Usage
show running-config ospf
EXEC Privilege View the summary of all OSPF process IDs enables on the
router.
Command Syntax Command Mode Usage
show ip route summary
EXEC Privilege View the summary information of the IP routes.
show ip ospf database EXEC Privilege View the summary information for the OSPF database.
Command Syntax Command Mode Usage
show ip ospf neighbor
EXEC Privilege View the configuration of OSPF neighbors.
FTOS#show run ospf
!
router ospf 3
!
router ospf 4
router-id 4.4.4.4
network 4.4.4.0/28 area 1
!
router ospf 5
!
router ospf 6
!
router ospf 7
mib-binding
!
router ospf 8
!
router ospf 90
area 2 virtual-link 4.4.4.4
area 2 virtual-link 90.90.90.90 retransmit-interval 300
!
ipv6 router ospf 999