Open Shortest Path First (OSPFv2 and OSPFv3) | 775
Use the following command in EXEC Privilege mode to configure the debugging options of an OSPFv3
process:
Command Syntax Command Mode Usage
debug ipv6 ospf [event | packet]
{type slot/port}
EXEC Privilege View debug messages for all OSPFv3 interfaces.
•
event: View OSPF event messages.
• packet: View OSPF packets.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information
(e.g., passive-interface gi 2/1).
• For a port channel, enter the keyword
port-channel
followed by a number from 1 to 255 for TeraScale and
ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information
(e.g., passive-interface ten 2/3).
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094 (e.g., passive-interface
vlan 2222).
E-Series ExaScale platforms support 4094 VLANs with
FTOS version 8.2.1.0 and later. Earlier ExaScale supports
2094 VLANS.
To Next Page
Loading...
