Stacking | 987
4 Member not present
5 Member not present
6 Member not present
7 Member not present
8 Member not present
9 Member not present
10 Member not present
11 Member not present
Figure 47-9. Adding an S4810 Stack Unit with a Conflicting Stack Number—After
FTOS#show system brief
Stack MAC : 00:01:e8:8a:df:e6
Reload Type : normal-reload
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
---------------------------------------------------------------------------
0 Management online S4810 S4810 8-3-7-13 64
1 Member online S4810 S4810 8-3-7-13 64
2 Member not present
3 Standby online S4810 S4810 8-3-7-13 64
4 Member not present
5 Member not present
6 Member not present
7 Member not present
8 Member not present
9 Member not present
10 Member not present
11 Member not present
Add a Configured Unit to an Existing Stack
To add a configured unit to an existing stack use the following steps.
If a stack unit goes down and is removed from the stack, the logical provisioning configured for that
stack-unit number is saved on the master and standby units. When a new unit is added to the stack, if a
stack group configuration conflict occurs between the new unit and the provisioned stack unit, the
configuration of the new unit takes precedence.
Step Task Command Syntax Command Mode
1 Add the configured unit to the top or bottom of the stack.
2 Power on the switch.
3 Attach cables to connect ports on the added switch to one or more existing switches in the stack.
4 Logon to the CLI and enter global configuration
mode.
Login: username
Password: *****
FTOS> enable
FTOS# configure
To Next Page
Loading...
