Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

TX1320 M1 Upgrade and Maintenance Manual 107
6 Power supply
This chapter provides information on how to handle a standard power supply
unit (PSU).
About power supply configurations
The PRIMERGY TX1320 M1 server is equipped with a standard PSU.
V CAUTION!
The server supports a mains voltage in the range of 100 V - 240 V. You
may only operate the server if its rated voltage range corresponds to the
local mains voltage.
Safety notes
V CAUTION!
● Do not disassemble the PSU. Doing so may cause electric shock.
● Areas around the PSU may remain extremely hot after shutdown.
After shutting down the server, wait for hot components to cool down
before removing PSUs.
● The PSU is heavy, so handle it carefully. If you drop it by mistake,
injuries may result.
● For further safety information, please refer to chapter "Important
information" on page 31.

Fujitsu PRIMERGY TX1320 M1 Specifications

General

Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Celeron
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
RAID Support	RAID 0, 1, 10
Network Controller	Dual-port Gigabit Ethernet
Operating System Support	Linux