Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

TX1320 M1 Upgrade and Maintenance Manual 215
10 Main memory
This section provides information on how to install, remove or replace memory
modules.
Safety notes
V CAUTION!
● Do not install unsupported third party memory modules. For further
information on supported memory modules, refer to section "Basic
information" on page 216.
● Memory modules remain hot after shutdown. Wait for components to
cool down before installing or removing memory modules to prevent
burns.
● Do not insert and remove memory modules repeatedly. Doing so may
cause failures.
● Pressing out the securing clips on the memory module connector will
eject the installed memory module. To prevent damage and injuries
eject memory modules carefully without applying excessive force.
● For further information, please refer to chapter "Important
information" on page 31.
In this chapter
● "Memory sequence" on page 217
● "Operation modes" on page 218
● "Installing memory modules" on page 220
● "Removing memory modules" on page 218
● "Replacing memory modules" on page 221

Fujitsu PRIMERGY TX1320 M1 Specifications

General

Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Celeron
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
RAID Support	RAID 0, 1, 10
Network Controller	Dual-port Gigabit Ethernet
Operating System Support	Linux