Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

TX1320 M1 Upgrade and Maintenance Manual 139
Hard disk drives / solid state drives
7.3.4.3 Installing a 3.5-inch HDD module
Ê Install the replacement HDD module into the empty drive bay as described
in section "Installing a 3.5-inch HDD module" on page 130.
7.3.4.4 Concluding steps
Perform the following procedures to complete the task:
Ê Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 100.
Ê Close the front cage as described in section "Closing the front cage" on
page 62.
Ê Close the server cover as described in section "Mounting the server cover"
on page 66.

Fujitsu PRIMERGY TX1320 M1 Specifications

General

Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Celeron
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
RAID Support	RAID 0, 1, 10
Network Controller	Dual-port Gigabit Ethernet
Operating System Support	Linux