Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

292 Upgrade and Maintenance Manual TX1320 M1
System board and components
Destroying the defective UFM
V CAUTION!
The UFM contains customer information (e.g. IP address, license
numbers). After replacing the UFM, hand the defective UFM over to the
customer. If the customer requests disposal of the defective UFM,
proceed as follows:
Figure 177: Destroying the defective UFM
Ê Use a pair of combination pliers (1) and flat nose pliers (2) to break
the UFM in half as shown.
14.3.3.4 Concluding steps
Ê "Closing the server" on page 64
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 71
Ê "Enabling SVOM boot watchdog functionality" on page 92
Ê "Enabling BitLocker functionality" on page 99

Fujitsu PRIMERGY TX1320 M1 Specifications

General

Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Celeron
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
RAID Support	RAID 0, 1, 10
Network Controller	Dual-port Gigabit Ethernet
Operating System Support	Linux