Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

TX1320 M1 Upgrade and Maintenance Manual 71
Basic hardware procedures
4.9 Switching on the server
V CAUTION!
● Before switching on the server, make sure the server cover is closed.
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY TX1320 M1 server must not run while the server cover
is removed.
● Follow the safety instructions in chapter "Important information" on
page 31.
Ê Connect all peripheral cables to the rear connector panel of the server.
Ê Connect and secure the power cord as described in section "Connecting the
server to the mains" on page 67.
Ê Connect the power cord to the power outlet.
Ê install the security cover as described in section"Installing the security
cover" on page 69.
Figure 27: Power button on the front panel
Ê Press the On / Off button to start up the server (1).
Ê Ensure that the power-on indicator above the On / Off button is lit green.
I For more information see "Front panel controls and indicators" on
page 335.
0

Fujitsu PRIMERGY TX1320 M1 Specifications

General

Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Celeron
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
RAID Support	RAID 0, 1, 10
Network Controller	Dual-port Gigabit Ethernet
Operating System Support	Linux