Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

222 Upgrade and Maintenance Manual TX1320 M1
Main memory
Ê "Disconnecting power cords" on page 53
Ê "Opening the server" on page 55
Ê "Removing the system fan module" on page 153
Ê Locate the defective memory module using the onboard Local Diagnostic
LEDs (see section "Onboard indicators and controls" on page 328).
10.4.2 Removing the defective memory module
Ê Remove the memory module as described in section "Removing a memory
module" on page 219.
10.4.3 Installing the new memory module
Ê Install the memory module as described in section "Installing a memory
module" on page 220.
10.4.4 Concluding steps
Ê "Installing the system fan module" on page 156
Ê "Closing the server" on page 64
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 71
Ê If applicable, "Updating or recovering the system board BIOS and iRMC" on
page 82
Ê "Enabling SVOM boot watchdog functionality" on page 92
Ê "Enabling replaced components in the system BIOS" on page 92
Ê "Verifying the memory mode" on page 94
Ê "Enabling BitLocker functionality" on page 99

Fujitsu PRIMERGY TX1320 M1 Specifications

General

Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Celeron
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
RAID Support	RAID 0, 1, 10
Network Controller	Dual-port Gigabit Ethernet
Operating System Support	Linux