10.2.2 Removing a memory module
Ê Identify the desired memory slot see section "Memory sequence" on
page 217.
V CAUTION!
Ensure to maintain an operational configuration when removing
memory modules. For additional information, please refer to section
"Basic information" on page 216.
Figure 118: Removing memory modules
Ê Eject the desired memory module by pressing out the securing clips at each
end of the memory slot (1).
Ê Remove the ejected memory module (2).
10.2.3 Concluding steps
Ê "Installing the system fan module" on page 156
Ê "Closing the server" on page 64
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 71
Ê If applicable, "Updating or recovering the system board BIOS" on page 82
Ê "Enabling SVOM boot watchdog functionality" on page 92
Ê "Enabling BitLocker functionality" on page 99
To Next Page
Loading...
