Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

52 Upgrade and Maintenance Manual TX1320 M1
Basic hardware procedures
4.2 Shutting down the server
V CAUTION!
For further safety information, please refer to chapter "Important
information" on page 31.
I This step is only required when upgrading or replacing non-hot plug
components.
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 73.
Ê Inform the system administrator that the server will be shut down and put
offline.
Ê Terminate all applications.
Figure 8: Power button on the front panel
Ê Shut down the server.
I If the system is running an ACPI-compliant operating system, the
pressing the On / Off button will performs a graceful shutdown.
Ê Switch on the ID indicator on the front and rear connector panels of the
server as described in section "Locating the defective server" on page 44.
0

Fujitsu PRIMERGY TX1320 M1 Specifications

General

Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Celeron
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
RAID Support	RAID 0, 1, 10
Network Controller	Dual-port Gigabit Ethernet
Operating System Support	Linux