Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

TX1320 M1 Upgrade and Maintenance Manual 199
Expansion cards and backup units
9.4 Additional tasks
This section provides additional expansion card related information on how to
install slot brackets and SFP+ transceiver modules.
I For further instructions regarding controller settings, please refer to the
accompanying documentation.
9.4.1 Mounting expansion card slot brackets
This section provides general instructions on mounting slot brackets as well as
specific instructions for the following network adapters:
● "Network adapter D2735" on page 201
● "Network adapter D2745" on page 203
● "Network adapter D2755" on page 205
Customer Replaceable Unit
(CRU)
Hardware: 5 minutes
Tools:
Preliminary and concluding steps: tool-less
Mounting slot brackets: Phillips PH2 / (+) No. 2 screw driver

Fujitsu PRIMERGY TX1320 M1 Specifications

General

Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Celeron
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
RAID Support	RAID 0, 1, 10
Network Controller	Dual-port Gigabit Ethernet
Operating System Support	Linux