4.6 Closing the server
V CAUTION!
●
Before attaching the covers, make sure no unnecessary parts or tools
are left inside the server.
●
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY TX1320 M1 server must not run while the side cover is
removed.
●
For further safety information, please refer to chapter "Important
information" on page 31.
4.6.1 Mounting the hard disk drive cover
Figure 20: Installing the hard disk drive cover
Ê Insert the hard disk drive cover with the lower side into the side / top
cover (1).
Ê Close the hard disk drive cover (2).
/
0
To Next Page
Loading...
