Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

118 Upgrade and Maintenance Manual TX1320 M1
Hard disk drives / solid state drives
7.2.2 Installing 2.5-inch HDD / SSD modules
7.2.2.1 Preliminary steps
Before installing a 2.5-inch HDD / SSD module, perform the following steps:
Ê Remove the hard disk drive cover as described in section "Removing the
hard disk drive cover" on page 59.
Ê Locate the correct drive bay as described in section "Mounting order for 2.5-
inch HDDs / SSDs" on page 117.
Customer Replaceable Unit
(CRU)
Hardware: 5 minutes
Tools:
Preliminary and concluding steps: tool-less
Installing a 2.5-inch HDD / SSD module: tool-less

Fujitsu PRIMERGY TX1320 M1 Specifications

General

Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Celeron
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
RAID Support	RAID 0, 1, 10
Network Controller	Dual-port Gigabit Ethernet
Operating System Support	Linux