7.2.4.2 Removing a 2.5-inch HDD / SSD module
Ê Remove the HDD / SSD module to be replaced from the server as described
in section "Removing a 2.5-inch HDD / SSD module" on page 123.
7.2.4.3 Installing a 2.5-inch HDD / SSD module
Ê Install the replacement HDD / SSD module into the empty drive bay as
described in section "Installing a 2.5-inch HDD / SSD module" on page 120.
7.2.4.4 Concluding steps
Perform the following procedures to complete the task:
Ê Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 100.
Ê Install the hard disk drive cover as described in section "Mounting the drive
cover" on page 65.
To Next Page
Loading...
