14.5.5 Concluding steps
Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section "Cabling" on page 319.
Ê Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: refer to section "Installing the processor heat sink" on
page 231
– Memory modules: refer to section "Installing a memory module" on
page 220
I Install all memory modules into their original slots.
– Expansion cards: refer to section "Installing a memory module" on
page 220
I Install all expansion cards into their original slots.
– UFM (if applicable): refer to section "Installing the UFM" on page 285
– TPM (if applicable): refer to section "Installing the TPM" on page 293
Ê "Installing the system fan module" on page 156
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
Ê "Closing the server" on page 64
Ê Reconnect all external cables.
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 71
Ê "Updating or recovering the system board BIOS and iRMC" on page 82
Ê "Verifying system information backup / restore" on page 86
Ê If customer BIOS settings are not restored automatically, please change the
settings manually (using the information collected during "preliminary
steps"). If you couldn't determine the BIOS version, ask the customer to
reconfigure all BIOS settings and the password.
To Next Page
Loading...
