4.3 Opening the server
V CAUTION!
●
Before removing or installing covers, turn off the server and all
peripheral devices. Also unplug all power cables from the outlet.
Failure to do so can cause electric shock.
●
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY TX1320 M1 server must not run while the side cover is
removed.
●
For further safety information, please refer to chapter "Important
information" on page 31.
Ê Shut down and power off the server as described in section "Shutting down
the server" on page 52.
Ê Unlatch and remove the power cord from the power supply units as
described in section "Disconnecting power cords" on page 53.
Ê Remove all external cables from the rear connector panel and expansion
cards. For further information, refer to section "Connectors and indicators"
on page 325.
To Next Page
Loading...
