9.2.3.2 Removing an expansion card
Ê If applicable, remove SFP+ transceiver modules from the expansion card to
be removed, as described in section "Replacing SFP+ transceiver modules"
on page 214.
Ê Remove the defective expansion card as described in section "Removing
expansion cards" on page 178.
9.2.3.3 Installing an expansion card
Ê Install the new expansion card as described in section "Installing expansion
cards" on page 174.
Ê If applicable, reinstall SFP+ transceiver modules on the replacement
expansion card, as described in section "Installing SFP+ transceiver
modules" on page 207.
9.2.3.4 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "Cabling" on
page 319.
9.2.3.5 Concluding steps
Perform the following procedures to complete the task:
Ê Close the server cover as described in section "Closing the server" on
page 64.
Ê If applicable, connect external cables to the expansion card.
Ê Reconnect the AC power cord to the power supply unit.
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section "Updating RAID controller firmware" on page 87.
Ê Enable boot watchdog functionality as described in section "Enabling SVOM
boot watchdog functionality" on page 92.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 99.
To Next Page
Loading...
Need help?
General
