Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

68 Upgrade and Maintenance Manual TX1320 M1
Basic hardware procedures
Securing power cords
Figure 24: Securing power cord
Ê Connect the power cord to the power supply (1).
Ê Thread the cable tie through the eye.
Ê Pull the cable tie tight to secure the power cable (2).
The insulated connector cannot now be disconnected from the server
accidentally.
Ê Switch off the identification ID as described in section "Locating the defective
server" on page 44.
/
0
/

Fujitsu PRIMERGY TX1320 M1 Specifications

General

Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Celeron
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
RAID Support	RAID 0, 1, 10
Network Controller	Dual-port Gigabit Ethernet
Operating System Support	Linux