HEIDENHAIN TNC 620 Programming Station User Manual

Manual Operation and Setup | Moving the machine axes
16
636
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Features in the program run modes of operation
You can use the following functions in the Program Run modes of
operation:
The NC Start key (NC Start handwheel key)
The NC Stop key (NC Stop handwheel key)
After the NC Stop key has been pressed: Internal stop
(handwheel soft keys MOP and then Stop)
After the NC STOP key has been pressed: Traverse manual axes
(handwheel soft keys MOP and then MAN)
Returning to the contour after the axes were moved manually
during a program interruption (MOP and then REPO handwheel
soft keys). The handwheel soft keys, which function similarly to
the screen soft keys, are used for operating.
Further information: "Returning to the contour", page 733
On/off switch for the Tilt working plane function (handwheel soft
keys MOP and then 3D)

HEIDENHAIN TNC 620 Programming Station Specifications

General

Brand	HEIDENHAIN
Model	TNC 620 Programming Station
Category	Control Systems
Language	English