HEIDENHAIN TNC 620 Programming Station User Manual

Batch Process Manager | Batch Process Manager (option 154)
15
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
617
Editing a job list
There are two ways to create a job list:
In the pallet management
Further information: "Editing pallet tables", page 604
The control opens the pallet table (.p) in the Batch Process
Manager as a job list.
Directly in the Batch Process Manager
You can edit a line in the job list in the Batch Process Manager as
follows:
Open the desired job list
Press the EDIT soft key
Place the cursor on the desired line, e.g. Pallet
The control displays the selected line in blue.
The control displays the editable entries on the
right-hand side.
Press the CHANGE WINDOW soft key if required
The control switches the active window.
The following entries can be changed:
Name
Datum table
Preset
Locked
Editing possible
Confirm the edited entries by pressing the ENT
key.
The control adopts the changes.
Press the EDIT soft key

HEIDENHAIN TNC 620 Programming Station Specifications

General

Brand	HEIDENHAIN
Model	TNC 620 Programming Station
Category	Control Systems
Language	English