Tables and Overviews | Functions of the TNC 620 and the iTNC 530 compared
20
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
825
Function TNC 620 iTNC 530
Programming minor axes:
Syntax FUNCTION PARAXCOMP:
Define the behavior of the
display and the paths of traverse
Available Not available
Syntax FUNCTION PARAXMODE:
Define the assignment of the
parallel axes to be traversed
Available Not available
Programming OEM cycles
Access to table data
Via SQL commands
and via FN 17/FN 18 or
TABREAD-TABWRITE functions
Via FN 17/FN 18 or
TABREAD-TABWRITE functions
Access to machine parameters
With the CFGREAD function Via FN 18 functions
Creating interactive cycles with
CYCLE QUERY, e.g. touch probe
cycles in Manual Operation
Available Not available
Comparison: Differences in Test Run, functionality
Function TNC 620 iTNC 530
Entering a program with the GOTO
key
Function only possible if the
START SINGLE soft key was not
pressed
Function also possible after
START SINGLE
Calculation of machining time Each time the simulation is repeat-
ed by pressing the START soft key,
the machining time is totaled
Each time the simulation is repeat-
ed by pressing the START soft key,
time calculation starts at 0
Single block
With point pattern cycles and CYCL
CALL PAT, the control stops after
each point
Point pattern cycles and CYCL CALL
PAT are handled by the control as a
single block
To Next Page
Loading...
Need help?
General
