HEIDENHAIN TNC 620 Programming Station User Manual

MOD Functions | Counter settings
19
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
741
19.3 Counter settings
With the MOD function Counter settings, you can change the
current count (actual value) and the target value (nominal value).
Proceed as follows to select the Counter settings:
In the MOD menu, select the Counter settings group
Select the current count
Select the target value for the counter
Press the APPLY soft key
Press the OK soft key
The control immediately takes over the selected value in the status
display
You can change the Counter settings via soft key as follows:
Soft key Meaning
Reset count
Increase count
Lower count
You can also enter the values directly with a connected mouse.
Further information: "Defining a counter", page 512

HEIDENHAIN TNC 620 Programming Station Specifications

General

Brand	HEIDENHAIN
Model	TNC 620 Programming Station
Category	Control Systems
Language	English