HEIDENHAIN TNC 620 Programming Station User Manual

Test Run and Program Run | Program run
18
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
721
Manual program interruption
While a machining program is being executed in the Program
run, full sequence operating mode, select the Program run,
single block operating mode. The control interrupts the machining
process at the end of the current machining step.
Abort program run.
Press NC Stop key
The control does not exit the current NC block
The control shows the symbol for stopped status
in the status display
Actions such as a change of operating mode are
not possible
The program can be resumed with theNC Start
key
Press the INTERNAL STOP soft key
The control briefly shows the symbol for aborting
the program in the status display
The control shows the symbol for the exited
inactive status in the status display
Actions such as a change of operating mode are
available again

HEIDENHAIN TNC 620 Programming Station Specifications

General

Brand	HEIDENHAIN
Model	TNC 620 Programming Station
Category	Control Systems
Language	English