Juniper QFX5110 Series User Manual

Table 72: Chassis Status LEDs on a QFX5110 Switch
DescriptionStateColorName
The switch is halted or there is no
alarm.
OffUnlitALM–Alarm or beacon
A major hardware fault has occurred,
such as a temperature alarm or power
failure, and the switch has halted.
Power off the QFX5110 by setting the
AC power source outlet to the off (O)
position, or unplugging the AC power
cords. Correct any voltage or site
temperature issues, and allow the
switch to cool down. Power on the
QFX5110 and monitor the power
supply and fan LEDs to help determine
where the error is occurring.
On steadilyRed
A minor, non-critical alarm has
occurred, such as a software error.
Power off the QFX5110 by setting the
AC power source outlet to the off (O)
position, or unplugging the AC power
cords. Power on the QFX5110 and
monitor the status LEDs to ensure that
Junos OS boots properly.
On steadilyAmber
The switch is powered off or halted.OffUnlitSYS–System
Junos OS for QFX Series is loaded on
the switch.
On steadilyGreen
The switch is participating as:
•
A member in a QFX Virtual Chassis
•
A leaf device in a Virtual Chassis
Fabric (VCF)
•
A spine device in a VCF
•
A Routing Engine Primary in a VCF
•
A Routing Engine Backup in a VCF
BlinkingGreen
495

Juniper QFX5110 Series Specifications

General

Rack Units	1U
Operating System	Junos OS
Form Factor	Fixed
Management	CLI, SNMP, NETCONF
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Humidity	5% to 90% non-condensing
AC Power Input	100-240 VAC
Power Supply	Redundant, hot-swappable