Juniper QFX5110 Series User Manual

Table 83: QFX5100 Access Port and Uplink LED Locations (continued)
LocationIndicatorsPort TypeModel
Table 84 on page 512 describes how to interpret the SFP+ port LEDs.
Table 84: Network Port LEDs on SFP+ Ports on a QFX5100 Switch
DescriptionStateColorLED
The port is administratively disabled, there is no power,
the link is down, or there is a fault.
OffUnlitLink/Activity
A link is established, but there is no link activity.On steadilyGreen
A link is established, and there is link activity.Blinking
The beacon is enabled on the port. On QFX5100-48T, it
indicates a fault.
BlinkingAmber
The link is down.OffUnlitStatus
NOTE: Not
applicable for
QFX5100-48T or
QFX5100-48TH.
The beacon function is enabled on the port.BlinkingAmber
A 1-Gigabit Ethernet transceiver is installed in the port
and the link is established.
BlinkingGreen
A 10-Gigabit Ethernet transceiver is installed in the port
and link is established.
On steadilyGreen
512

Juniper QFX5110 Series Specifications

General

Rack Units	1U
Operating System	Junos OS
Form Factor	Fixed
Management	CLI, SNMP, NETCONF
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Humidity	5% to 90% non-condensing
AC Power Input	100-240 VAC
Power Supply	Redundant, hot-swappable