Table 133: QFX3600 and QFX3600-I Chassis Alarm Messages (continued)
Recommended ActionCLI MessageAlarm TypeComponent
For information only. Indicates that an
AC power supply and DC power
supply have been installed in the same
chassis. If you wish to remove this
alarm message, reboot the device with
two AC power supplies or two DC
power supplies.
For information only. Indicates the
device was powered on with two
power supplies installed, but one has
been removed. The device can
continue to operate with a single
power supply. If you wish to remove
this alarm message, reboot the device
with one power supply.
PEM pem-number Removed
Check the system log for the following
message and report it to customer
support:
Temp sensor sensor-number failed,
where sensor-number may range from
1 through 10.
sensor-location Temp Sensor FailMajor (red)Temperature
sensors
Check environmental conditions and
alarms on other devices. Ensure that
environmental factors (such as hot air
blowing around the equipment) are
not affecting the temperature sensor.
If the condition persists, the device
may shut down.
sensor-location Temp Sensor Too Hot
For information only. Check
environmental conditions and alarms
on other devices. Ensure that
environmental factors (such as hot air
blowing around the equipment) are
not affecting the temperature sensor.
sensor-location Temp Sensor Too
Warm
Minor (yellow)
631
To Next Page
Loading...
Need help?
General
