EasyManuals Logo

Juniper QFX5110 Series User Manual

Juniper QFX5110 Series
669 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #659 background imageLoading...
Page #659 background image
Table 134: QFX3500 Chassis Alarm Messages (continued)
Recommended ActionCLI MessageAlarm TypeComponent
For information only. Indicates the
device was powered on with two
power supplies installed, but now one
is missing. The device can continue to
operate with a single power supply. If
you wish to remove this alarm
message, reboot the device with one
power supply.
PEM pem-number AbsentMinor (yellow)
For information only. Check the power
cord connection and reconnect it if
necessary.
PEM pem-number is not powered
For information only. Indicates that an
AC power supply and DC power
supply have been installed in the same
chassis. If you wish to remove this
alarm message, reboot the device with
two AC power supplies or two DC
power supplies.
PEM pem-number Power Supply Type
Mismatch
For information only. Indicates the
device was powered on with two
power supplies installed, but one has
been removed. The device can
continue to operate with a single
power supply. If you wish to remove
this alarm message, reboot the device
with one power supply.
PEM pem-number Removed
635

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper QFX5110 Series and is the answer not in the manual?

Juniper QFX5110 Series Specifications

General IconGeneral
Rack Units1U
Operating SystemJunos OS
Form FactorFixed
ManagementCLI, SNMP, NETCONF
Operating Temperature32°F to 104°F (0°C to 40°C)
Storage Temperature-40°F to 158°F (-40°C to 70°C)
Humidity5% to 90% non-condensing
AC Power Input100-240 VAC
Power SupplyRedundant, hot-swappable

Related product manuals